Print Page | Close Window

Designtech first defense programming.

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=9482
Printed Date: August 19, 2025 at 11:35 AM

Topic: Designtech first defense programming.

Posted By: wlg83
Subject: Designtech first defense programming.
Date Posted: February 13, 2003 at 4:31 PM

Product #29646.... how is it that I program a new remote to the system? I know it involves the white momentary push-button, but cannot remember the rest. Thanks in advance for any help.

Replies:

Posted By: Derek
Date Posted: February 13, 2003 at 5:25 PM

wig83,

1. Have at least one door open.

2.Disconnect power by removing the 16 pin harness from the module for 5 seconds and then reconnect it.

3.Within 5 seconds, quickly push and release the White button on the side of the module. The LED will flash 2 times to tell you that the system is now in the learning mode.

4. Within 5 sec. hold down the lock/unlock button (#1) until the LED flashes 1X , indicating that it has learned the Xmtr. code. Do this again with each Xmtr. within 5 sec.

5. When done with all transmitters, wait until the LED flashes 5X indicating the system has exited the learning mode.

6.Close the door. Then try the transmitter(s)

-------------

Posted By: wlg83
Date Posted: February 14, 2003 at 2:36 PM

Thanks Derek. After I posted, I remembered not to hold the white button, but rather to tap it. Everything is working great.

Print Page | Close Window