Print Page | Close Window

07 dodge sprinter wiring schematics

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=94909
Printed Date: May 01, 2025 at 8:22 AM


Topic: 07 dodge sprinter wiring schematics

Posted By: desh187
Subject: 07 dodge sprinter wiring schematics
Date Posted: June 18, 2007 at 7:05 PM

Has anyone done an alarm on the 2007 Dodge Sprinter Van(new body style)?I have done up to the 06 and wondering if the wiring info is totally changed or still the same.
Thanks..



Replies:

Posted By: wire4veins
Date Posted: June 20, 2007 at 10:34 PM
DODGE / SPRINTER / 2007 / Security

[PRINT THIS PAGE]

12volts      RED / gray (25A), RED / gray (10A)      +       ignition harness
Starter      purple (not for remote start)       +       fuse box, rear 18 pin plug, pin 1
Notes: May not be able to do remote start on this vehicle because the ignition switch uses CAN data bus.
Ignition      black       +       ignition harness
Power Lock      use the motor wires       5wi     
Notes: The driver door motor wires are dk. blue/red - dk. blue/black at the DDM, 20 pin plug, pins 12 and 11.

The passenger door motor wires are dk. blue/red - dk. blue/black at the BCM, brown 52 pin plug, pins 49 and 48.

The side and rear motor wires are dk. blue/brown - dk. blue/black at the BCM, black 12 pin plug, pins 12 and 11.

The DDM (Driver Door Module) is in the driver door.

The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Power Unlock      use the motor wires       5wi     
Lock Motor      dk. blue/red       5wi      DDM, 20 pin plug, pin 12
Notes: The DDM (Driver Door Module) is in the driver door.
Unlock Motor      dk. blue/black       5wi      DDM, 20 pin plug, pin 11
Notes: The DDM (Driver Door Module) is in the driver door.
Disarm Defeat      dk. blue/black       5wi      BCM, brown 52 pin plug, pin 48
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Parking Lights+      gray/black (L), gray/red (R)       +       BCM, black 20 pin plug, pins 1, 12
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Parking Lights-      gray/white       -       BCM, brown 24 pin plug, pin 13
Notes: Parking lights are negative trigger thru a resistor. The resistor value is not known at this time. Cut this wire and meter the switch side to get the value.

The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Hazards      (CAN data bus)            
Turn Signal(L)      BLACK/ wht (F), BLACK/ wht (R)       +       BCM, brn 52 pin plg; blk 20 pin plg
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Turn Signal(R)      blk/dk. grn(F), blk/dk. grn(R)      +       BCM, brn 52 pin plg; blk 20 pin plg
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Door Trigger      see notes       -       see notes
Notes: The LF door is dk. blue/dk. green at the DDM, 20 pin plug, pin 8. The RF door is dk. blue/dk. green at the BCM, brown 52 pin plug, pin 43. The LR door is yellow/white at the BCM, brown 52 pin plug, pin 4. The RR door is pink/white at the BCM, brown 52 pin plug, pin 41. Use all four wires and diode isolate each.

The DDM (Driver Door Module) is in the driver door.

The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Dome Supervision      BROWN / dk. green       -       BCM, black 18 pin plug, pin 1
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Trunk/Hatch Pin      dk. blue/dk. green       -       BCM, black 20 pin plug, pin 6
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Hood Pin      BROWN / pink       -       BCM, brown 24 pin plug, pin 6
Notes: The BCM (Body Control Module) is attached to the fuse/relay box in the driver kick panel.
Trunk/Hatch Release      N/A            
Power Sliding Door      N/A            
Factory Alarm Arm      factory remote only            
Factory Alarm Disarm      factory remote only            
Disarm No Unlock      with key sense and Transponder           
Tachometer      NOT BLACK/ white or BLACK/ gray       ac       any fuel injector
Notes: On diesel models, the tach wire is yellow/gray at the ECM, black 94 pin plug, pin 33.

The ECM (Engine Control Module) is on the driver fender behind the battery.
Horn Trigger      dk. green       +       fuse box, rear 18 pin plug, pin 16
Memory Seat 1      N/A            
Memory Seat 2      N/A            
Memory Seat 3      N/A            
Interface Module:      Category:
Immobilizer Bypass      Required:
Yes      Type:
Transponder
Part #: 556UW
Alternate Part1 #: DesignTech 20402
Alternate Part2 #: DesignTech 29402
Notes: Standard on all models. May not be able to do remote start on this vehicle because the ignition switch uses CAN data bus.
Smart Starter Kill Relays: Not Available


-------------
wire4veins
"D"
Precision Autosound - Owner
MECP Master Installer





Print Page | Close Window