1999 lincoln navigator rsx 3.5
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=94987
Printed Date: June 07, 2024 at 11:34 PM
Topic: 1999 lincoln navigator rsx 3.5
Posted By: mortarb2
Subject: 1999 lincoln navigator rsx 3.5
Date Posted: June 21, 2007 at 2:06 PM
Every wire is hooked up correctly or so I assume, I have triple checked. The only things not hooked up are the hood pin switch and the neutral safety switch. Yet when I press the remote start button, I get nothing. The module does not even click. When I press unlock/lock on the remote the module makes a click sound and then does the correct function. Yet when I press the remote start button I get no response whatsoever. Any ideas?
Replies:
Posted By: JWorm
Date Posted: June 21, 2007 at 2:54 PM
The neutral safety wire must be grounded. Usually the wire is run thru the little toggle switch that comes with the unit so the remote start can be disabled when servicing the vehicle.
Posted By: mortarb2
Date Posted: June 21, 2007 at 3:02 PM
So this will solve my problems? Is this the reason behind the module not working at all?
Posted By: JWorm
Date Posted: June 21, 2007 at 3:39 PM
It will solve your problems if everything else is correct. If the neutral safety wire does not see ground, the unit will have NO RESPONSE if you try to remote start. Make sure you learn the tach signal before trying to remote start.
Also, don't make multiple posts for multiple problems with the same install. Keep all questions in the same thread. It makes it easier for us to follow your progress. I think it is also in the forum rules.
Posted By: altytruck
Date Posted: June 21, 2007 at 7:47 PM
yes, you should use the toggle switch to control the remote start like JWorm says, ground one side of the switch and the other ends goes to the BLACK/ white of the h3 plug. Also connect the hood trigger wire. This way when someones working under the hood of your truck the remote start unit will not engage.
|