Print Page | Close Window

dodge magnum brake wire

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=95106
Printed Date: May 19, 2024 at 12:17 AM


Topic: dodge magnum brake wire

Posted By: Bigkevin20
Subject: dodge magnum brake wire
Date Posted: June 25, 2007 at 12:07 PM


I checked with the wire guid and it said it would be the GREEN / WHITE wire by pedal switch. Well I checked there is two wires one is GREEN / WHITE and the other is green. Well I used a volt meter and I dont get anything out of it when I press down the brake. So what else can I use for a brake wire? Its the only wire I dont have hooked up to the alarm yet.



Replies:

Posted By: pt_pimp313
Date Posted: June 25, 2007 at 12:53 PM
On some newer vehicles I have noticed that you have to have the vehicle on, not running, but just on, in order to test the brake wire. Most new GM's are like this. I haven't done a Magnum though.




Posted By: Bigkevin20
Date Posted: June 25, 2007 at 1:26 PM
ahhhh Ill have to try that




Posted By: Bigkevin20
Date Posted: June 25, 2007 at 3:15 PM
actually that wont work I tried that when I had the remote start running.




Posted By: Bigkevin20
Date Posted: June 25, 2007 at 4:14 PM
any body know where I can find the brake wire besides going all the way to the back




Posted By: pt_pimp313
Date Posted: June 25, 2007 at 6:06 PM
Well, why not look all the way in the back, then look in the driver or passenger kick panel for that same color. Directechs says dark GREEN / WHITE though for all 3 years of the Dodge Magnum.




Posted By: KarTuneMan
Date Posted: June 25, 2007 at 8:16 PM

The GREEN / WHITE between the 2 pink wires on the brake switch?

This should work!!!



-------------




Posted By: Bigkevin20
Date Posted: June 26, 2007 at 10:37 AM
Thanks guys.

dark GREEN / WHITE wire in pin 5 of stoplamp switch six pin connector should provide 12V when pedal is depressed.

in case you have trouble finding pin 5, pin 6 is pink/dark blue.





Print Page | Close Window