alarm programing latched

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=95205
Printed Date: May 19, 2024 at 6:15 PM

Topic: alarm programing latched

Posted By: 65gtoconv
Subject: alarm programing latched
Date Posted: June 29, 2007 at 5:37 AM

i have a black widow alarm and im trying to get the aux/trunk wire to switch from the momentary setting to the "latched" setting,,, but i cant get it to work.

i press the valet button 5 times then 9times for the aux and then bottom#4 for latched... but its not switching over.. im at my wits end with this thing,, what im i doing wrong

Replies:

Posted By: fkelsey
Date Posted: June 29, 2007 at 8:59 AM

Turn the ignition to the run not start setting. Push the valet 5 times the alarm should chirp. Pust the button the number of times to match the desired setting the alarm should chirp along with each push. Push the corresponding button on the remote.

Posted By: fkelsey
Date Posted: June 29, 2007 at 9:02 AM

Models I have in the shop number 12 is the aux 2 mode and button 3 on my remotes make it latched but it could be different on yours. There are a couple of models floating ou there.

Posted By: 65gtoconv
Date Posted: June 29, 2007 at 11:02 AM

i got it working,, thanks

Print Page | Close Window