2007 honda accord window

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=95670
Printed Date: May 03, 2025 at 1:28 PM

Topic: 2007 honda accord window

Posted By: six2six
Subject: 2007 honda accord window
Date Posted: July 17, 2007 at 12:37 AM

I've searched and found what wires to connect to an aftermarket alarm to do the window roll up and down. I'm using the clifford 50.5X. Only thing I don't understand is how the double pulse will work with the alarm? I see the aux channels can be programmed to be latched, latched with ignition reset and 30 sec. timed. I used the factory arm/disarm when I hooked up the alram for the remote start so I know where the wires are, but any help getting the windows hooked up will be greatly a[[reciated.

Thanks

Replies:

Posted By: KPierson
Date Posted: July 17, 2007 at 6:35 AM

You will have to run the wires in to the drivers door in order to tap the drivers key cylinder. Once you get a wire there, you can use your 'OEM disarm' wire with an Aux channel to lower the windows, and your 'OEM lock' wire with an Aux channel to raise the windows.

In order to get the windows to move on Hondas you need to send a short pulse to the key cylinder wire followed by a long pulse. The long pulse length will determine how far the windows move.

-------------
Kevin Pierson

Posted By: six2six
Date Posted: July 17, 2007 at 5:38 PM

Can the Clifford 50.5X send a short pulse when I press the aux button and then a long pulse when I press and hold the sux button? Any info will be greatly appreciated.

Thanks

Posted By: KPierson
Date Posted: July 17, 2007 at 6:26 PM

If they have a 'validity' output then that may be used. However, some validity outputs have a delay on them, that would make them hard to work with.

-------------
Kevin Pierson