04 diesel dodge.tach
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=95689
Printed Date: May 01, 2024 at 10:54 PM
Topic: 04 diesel dodge.tach
Posted By: superdart
Subject: 04 diesel dodge.tach
Date Posted: July 17, 2007 at 8:56 PM
OK, at this point I am losing my mind. We are installing a Python 990 in a 2004 Dodge Ram 2500 Diesel (automatic). The alarm is in and functioning correctly (to include programming) but we can't get it to start.
We have tapped Pin 24 of the forward ECM connector, AND tried the pin at the crankshaft sensor. It still won't crank. I know we need to crank it longer than normal, and we have it set for a 4 second crank time. However, to get it to crank that long, you need to shut off the tach sense in the program. At this point I'm lost.....HELP!!!!
Replies:
Posted By: burns25
Date Posted: July 17, 2007 at 10:36 PM
Ok, just a couple quick ones to check. Did you reprogram acc state during wait to start on? Also the 990 has wait to start built in so you don't even have to hook that up, it's feature 3-13 for future reference. Just out of curiosity does it do anything? Acc's, ign's kick on?
Posted By: superdart
Date Posted: July 17, 2007 at 10:50 PM
Acc state has been tried both set to on and off. Everything seems to be order during remote cranking, but I will double check.
There is the possibility we don't have an acc. hooked up correctly. We had to run another wire from the alarm remote module to the fuel relay, because it is an aftermarket fuel system. However, it is power off ign power, so if it's not coming on, maybe we missed something.
How many ign/acc wires should be hooked up?
|