I have a 2007 Ram 2500. I bought an Asianwolf 8100 RS system, and cannot figure out what goes where (Remote Start part only). I found the PURPLE / brown wire that comes out of the ignition switch. but cant figure out what to hook up.
My alarm diagram tells me the following
6 PIN HARNESS
BROWN WIRE: Second Ignition output. This wire may instead be programmed for use as a second acc. or second starter wire.
ORANGE WIRE: ACC out put (+)
YELLOW: Ignition Out (+) connect to the main ignition wire that provides +12v when the ignition is on and while cranking the starter.
VIOLET: Starter Output (+). Connect to the vehicles starter wire.
20 PIN HARNESS
Yellow: +12V Ignition Input. The yellow wire must connect to a main ignition wire at the ignition harness. This wire must show +12V when the ignition is on and while cranking the starter. The voltage must not drop whe the car is starting.
BLUE/ORANGE: Ground when running output (-) 500mA. cconnect to an optional factory security bypass module if required.
Anyhelp would be appreciated.
Sgt. Singh USMC
Hope this link will help you out
Dodge MUX diagram-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
i would take the truck to someone who knows how to do this as you can do a lot of damage on the new dodge chryslers if you dont know what you are doing there are a lot of thing on that pertitular truck that can make you life into a nightmare if you mess with them the multiplex sytems in that truck are quite complicated to an amature
-------------
"Computer games don't affect kids, I mean if Pac Man affected us as kids, we'd
all run around in a darkened room munching pills and listening to repetitive
music."-Kristian Wilson, Nintendo Inc.