1997 mitsubishi eclipse alarm/rs

I am installing a Scytek 5000RS Alarm/RS on this vehicle and I have finished the wiring. It is not remote starting....I have double checked all wiring and have tested every wire that I have hooked up....I even tested the alarm/rs Brain on another vehicle that I have installed it on and the brain is fine. No crank...and it is an automatic. PLease HELP....maybe anothe starter wire?? I checked all the wires at the cylinder and i havent tested another starter wire so....I am totally stumped on this one. I dont know what to do.....HELP!!!!! Thanx.....

sooooooooo.....

2) Do the dash lights come on? (i.e. does ignition come acc then ignition come on and THEN it fails?)

12 VOLT CONSTANT	WHITE (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/ RED (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	BLACK/ WHITE (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY /HEATER BLOWER 1	BLUE/BLACK (+)	IGNITION SWITCH HARNESS
ACCESSORY /HEATER BLOWER 2	N/A

only one starter wire and one ignition wire.

Where's your tach source?

Have you tach learned/sensed the brain yet?

Does the car chirp/honk to indicate successful transmission of RF from keyfob to alarm brain/antenna?

-------------
The search function is your friend.

lights come on then fail...then trys again and fails....and no successful indication for started vehicle...i think it is the tach wire...because i didnt hook it up because my system is setup for tachless and i have never had a problem with it on any other car i have installed it on...maybe this one is different...is there any other way to catch the tach wire besides the harness behind the cluster??? it is hard to get the wire and tap into it....any help thanx alot

Try using an injector

where are the injector wires located and what color?

Black plastic box on top of or level with engine cover runs parallel to it. 2 wires to each of 4 injector ports, one wire is the same in each case, DONT use this one , use one of the other 4 colours!

i hooked up the tach wire and learned tach...double checked all wiring and tested all wires hooked up..... still no crank.....is there a second starter wire im missing or ignition wire?>??? i switched the brains from a working vehicle and still no crank at all....please help.......thanx

This one is bugging me! I have a 99 Galant, it has a second ignition but you can start car without this. Read the install guide and check the trouble shooting section. Could you have gone to the second ign, A/c heater windows etc but not the primary? Everyone in USA says this is  BLACK/ red but on my Galant it's RED / black.

Sorry I meant starter colour.

Double check your wiring to this spec.

https://www.vfaq.com/mods/wiring-gen2wir.html

You should be able to find plenty vehicle specific questions there for the DSMs.

Also, did you try bumping the starter manually with your RS harness?

so there might be two starter wires in the car???....imma check the rest of the harness maybe tom