compustar remote start doesnt crank?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=96149
Printed Date: May 28, 2024 at 9:46 PM
Topic: compustar remote start doesnt crank?
Posted By: ikhmaifosho
Subject: compustar remote start doesnt crank?
Date Posted: August 03, 2007 at 7:15 PM
Hi, i have a 98 Honda Civic EX and just installed a Compustar CM3000, everything thing works fine execpt for the R/S. i bypass the clutch, learned tach but when i try to R/S it on reservation mode it doens't want to crank over, i can see the dash light up ready to crank but doesn't and it keeps trying and trying until i stop it, does anybody have suggestions?
Replies:
Posted By: swerks
Date Posted: August 03, 2007 at 7:35 PM
have you leaned the tach? (the button on the side) start car let reach normal idle then press button lights will flash and tach is learned.
------------- Steve Sverdahl
Swerksound Auto Electric
Red Deer Alberta
Posted By: ikhmaifosho
Date Posted: August 03, 2007 at 8:03 PM
yes i have learned tach because i pressed while car was on idle and i got a one chirp to confirm it was tach
Posted By: KarTuneMan
Date Posted: August 03, 2007 at 11:54 PM
How did you get past the clutch? When you try to R/S, and it fails.....are you going thru the safty sequence? -------------
Posted By: ikhmaifosho
Date Posted: August 04, 2007 at 12:41 AM
KarTuneMan wrote:
How did you get past the clutch? When you try to R/S, and it fails.....are you going thru the safty sequence?
i tap clutch wires together so it can start without the clutch down, and what do u mean safty sequence, like the cars in running after the key has been removed and when the door is closed then it shuts down because it does that with the e-brake up
Posted By: JWorm
Date Posted: August 04, 2007 at 7:21 AM
You may have the yellow and yellow/black starter kill wires backwards.
Posted By: ikhmaifosho
Date Posted: August 04, 2007 at 11:58 AM
no i got it correct, and i found out it was the Starter output in CN2 that wasn't connected but i still dont know y it doesn't lock itself after an remote start?
Posted By: JWorm
Date Posted: August 04, 2007 at 12:10 PM
When you exit the car it should shut off, lock the doors and arm itself. Why would it lock itself again after remote starting?
Posted By: dswift
Date Posted: August 06, 2007 at 11:30 AM
Well what did you use for your transponder? Does the car turn off and one 3 times? Pay attention to your dash board lights. When it first starts and then turns off pay attention to the green key light. You needs a honda bypass module. 98 should have a transponder.
------------- "dont ground out!"
Posted By: JWorm
Date Posted: August 06, 2007 at 2:23 PM
dswift wrote:
Well what did you use for your transponder? Does the car turn off and one 3 times? Pay attention to your dash board lights. When it first starts and then turns off pay attention to the green key light. You needs a honda bypass module. 98 should have a transponder.
The Civic didn't get a transponder key until 2001.
|