remove starter kill?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=96225
Printed Date: May 11, 2025 at 4:22 AM

Topic: remove starter kill?

Posted By: randiggy78
Subject: remove starter kill?
Date Posted: August 07, 2007 at 11:28 AM

I was recently removing an old alarm out of my car. A 1996 Toyota Corolla. It was an Audiovox PRO-9744. I am putting a Viper 791XV in. There was a relay sort of device in there with only 4 pins (i think). One was hooked up to the yellow wire on the audiovox (ignition) and there was an ORANGE / red (forgot where it went on the audiovox). There was a thick gauge black and a BLACK/ white. When I snipped these last two wires, the car didn't start. The wires went straight to the fusebox. When I hooked them back up, it started fine. How do I successfully remove this piece and have a seamless install with the Viper?

Any help is greatly appreciated

-------------
hell ya

Replies:

Posted By: swamprat323
Date Posted: August 07, 2007 at 11:55 AM

the BLACK/ white wire after u remove them form the relay just splice them toghter.

Posted By: randiggy78
Date Posted: August 07, 2007 at 12:36 PM

i dont know if that will work. the wires i mentioned don't go to the ignition switch. from what i saw there was a black and a BLACK/ white. they were both hooked up to different pins and both ran to the fusebox seperately. where would i splice them?

-------------
hell ya

Posted By: swamprat323
Date Posted: August 07, 2007 at 10:45 PM

soory i miss red your post your car th eBLACK/ white wire is the starter wire. on the relay that you took out did that have the black and the BLACK/ white wire on the same relay. if that was it splice them toghter.