2007 infiniti g35x remote starter

I Just bought 2007 infiniti g35x. Does anyone has the wire diagram, and know how to install the remote starter for this car?. This new car has PUSH BUTTON AND PUSH ON THE BRAKE to start the vehicle and not needs the key. Could someone show me how to do it?. Thanks

-------------
hhh

Check this out to see what you're in for. 2007 Infinity G35

-------------
Prepare your future. It wasn't the lack of stones that killed the stone age.

Thanks guys, This really helpful . Now I can install my alarm/starter for my car. Thanks again.

-------------
hhh

could someone tell me, what is the color wire for tach on 2007 infiniti g35x, and where does it located ?. Thanks.

-------------
hhh

TACH SIGNAL

GREEN/ red or Gray

At ECM below glovebox on right side of blower motor

AC

-------------

Could someone send me the color wire for 2007 infiniti g35x.?. I have two different color wire charts(from THE12VOLT and ASTROFLEX electronic), and I don't know which one to use. Thanks

-------------
hhh

Use them both and meter all your wires and you will be fine.

infiniti2007 wrote:

---

Could someone send me the color wire for 2007 infiniti g35x.?. I have two different color wire charts(from THE12VOLT and ASTROFLEX electronic), and I don't know which one to use. Thanks

---

Nothing like a third and conflicting opinion to clear up any confusion

-------------
Prepare your future. It wasn't the lack of stones that killed the stone age.

use the astrochart info it is the finest wire chart software in the world. check all circuts wit a dmm if you are not sure. or have it professonaly installed infinity parts are expensive and damage ispossible if not correctly installed


-------------
Steve Sverdahl
Swerksound Auto Electric
Red Deer Alberta

Hi everyone,
I try to install my two way remote starter and alarm to my 2007 infiniti g35x. I hooked up my remote start with CAN-SL2 (ver 1.9). I got everything working fine except the vehicle start for more than 15 seconds then it shut off and restart it again. But the second attempt, I see the NO KEY in the speedometer panel. But I thought the CAN-SL2 will take care of that. Could someone tell me what is the problems?. Thanks

Your tach signal is not right. I've had this problem in the past with a few vehicles as well where it would run for almost a minute and then shut off. Try another tach wire and relearn the tach.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

I think Jeff's right.

Also, you could temporarily re-program your unit for voltage sensing, as a troubleshooting tool.

If it works on voltage sense, then it's definitely the tach that's wrong......try switching to something else.

This is no tach connection on can-sl2. all you connect tach wire of can-sl2 to tach of remote start, and it will find tach itself through data link from bcm of vehicle ( you hooked data link from can-sl2 to data link of vehicle) . I still don' t know why it shut off after started, and sometimes it works perfectly.

-------------
hhh

Those tach connections aren't always the best i've had issues with some data tach connections before try a direct connection even if you just float a wire to actually test the system or put it on voltage sensing like chris mentioned.

IDATALINK       ADS-DLSL-CA

Your gonna have the time of your life installing this on 07 Altima and G35.

www.idatalink.ca

-------------
Take your time, a solution is just around the corner :-)

Thanks guys. I got it to work. I guess the data tach connections does not works, and I tried to connect the tach of the remote to the tach of vehicle and still does not work, finally I switch to the voltage sensing and it works perfectly. Thanks again.

-------------
hhh

There may be something you did wrong,  the tach from the vehicle didn't learn.  Which wire did you use???

Ah sorry, I should have paid more attention the first time.

The CAN-SL2i's tach output is incredibly crappy.

It'll work about 80% of the time.

Sometimes it doesn't put out any tach signal, and the remote starter will just keep on grinding the car's starter motor, even after the engine is already running.

Those cars work just fine on voltage sense.

Hi, I have installed the alarm/remote start on my 07 infiniti g35x. I got it working perfectly, but Just one problem on the (-) door unlock. Sometimes it works and sometimes it does not. Every time, I disarm the system, sometime it does not unlock the doors (It does disarm the system), and sometime it works (unlock and disarm the system). Could someone tells me what is the problems ?.     Thanks.

-------------
hhh

I have 07 infiniti g35x. I already installed 2 way remote starter/alarm to this vehicle. This alarm unit has no name (made in china), I got it from ebay. I got everything working perfectly, but only problem on the door UNLOCK. If you arm the system and disarm it within half an hour, it works perfectly. but if you arm the vehicle and leave it over hours and then disarm it, It will disarm the system but it DO NOT UNLOCK the doors. Could someone tells me, what is the problems?. Thanks.

-------------
hhh

Door unlock requires double pulse unlock to work.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

yes, I already set double pulse. Well it works fine, if you arm and disarm within 30 minutes. But if you armed it and leaves for a couple hours and try to disarm it . The doors are not unlock.

-------------
hhh

i would use a  data module to control the doorlocks . which also controls the arm and disarm of the vehicle through the dat bus line and ties into your remote starter . If problems persist you will have to get the system of the car flashed . Ive seen this before on the infiity g35 

-------------
Cameron : Tint King
1780 albion rd
rexdale , ontario

How do you use the data module to control the doorlocks?.What do you mean to get the system of the car flashed?. Thanks

-------------
hhh

How do you test the doors lock/unlock wire with digital multi meter?.

-------------
hhh

I have hard time to find the unlock wire for 07 infiniti g35x. They said it is blue/white at the driver side kick. Could someone tells me, where exactly it located and how do you test it with DDM?. Thanks

-------------
hhh

I got the alarm/remote starter, it made in china (no name). The unlock pulse takes too long to activate. Is there a way to speed up the unlock pulse?.

-------------
hhh

Could someone tells me where is unlock wire (Blue/white) for this vehicle. I looked at the driver side kick, I could not find it. Is it inside the driver' s side door?.

-------------
hhh

Hi,
    Does anybody knows, how to program the remote starter/alarm to the intelligent keys of the 2007 infiniti g35x?.

-------------
hhh