04 gm suburban, alarm/remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=96567
Printed Date: April 24, 2024 at 2:31 AM
Topic: 04 gm suburban, alarm/remote start
Posted By: galaxie500
Subject: 04 gm suburban, alarm/remote start
Date Posted: August 22, 2007 at 12:20 AM
Installed a remote start/alarm combo. Used a DEI 457GW to interface data bus door lock system. Problem: it seems that the vehicle now does not respond to it's keys and will not start. Factory theft light comes on when ign is on but begins to flash after a few moments. This is a 2004 Suburban. Any thoughts would be helpful. How does one reprogram keys, other than taking it to the dealership? ------------- TGG
Replies:
Posted By: Mike M2
Date Posted: August 22, 2007 at 7:00 AM
Did you wire up the smaller 3 pin plug? It shouldn't be used, it's for PS3 only and will make the truck not start...
-------------
Mike M2
Tech Manager
CS Dealer Services
Posted By: galaxie500
Date Posted: August 22, 2007 at 8:59 AM
No, I did not use the 3 pin plug, used only the main harness: 12v, gnd, date, door trigger. I then programed the 457gw per instructions.
-------------
TGG
Posted By: docsautomotive
Date Posted: August 22, 2007 at 11:48 PM
first try un hooking unit then try restarting with keys if it starts then you have your wires wrong let me know what happens and what kind of connections did you use
-------------
never stop
Posted By: galaxie500
Date Posted: August 23, 2007 at 12:56 AM
Faulty ground. Ground to the pass lock II interface was poor. After unhooking the Pass lock II interface, allowing the car to sit for about 10 minutes then it started. Reconnected, double checked all connections, system works fine.
-------------
TGG
|