hooked up alarm, pager says error
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=96588
Printed Date: July 05, 2025 at 10:54 AM
Topic: hooked up alarm, pager says error
Posted By: oblique
Subject: hooked up alarm, pager says error
Date Posted: August 22, 2007 at 9:01 PM
I hooked up an Airwolf alarm but the pager says error. I have only hooked up the power wires(12V, IGN 1, IGN 2) and I have a starter interrupt relay hooked up. Do I have to have the door sensor hooked up for the alarm to function? What is the minimum I need to have connected.
I plan on hooking everything else up, I just wanted to see if the alarm worked before I started cutting a lot of wires.
Replies:
Posted By: JWorm
Date Posted: August 22, 2007 at 9:29 PM
You didn't mention hooking up the ground wire...that will need to be done before it works correctly. I'll also assume you hooked up the antenna.
Some units need to have the pager remote programmed to the unit before it will work. Some alarms need to have the door trigger hooked up to enter remote programming. I have not used an Airwolf alarm before, so I'm not sure if these things apply to your alarm.
Good luck.
Posted By: oblique
Date Posted: August 22, 2007 at 11:40 PM
Ground wire and antenna are both hooked up. When I go to program the remote, the display says error and "d00-" I think "d00-" means "door" but I'm not sure.
|