2008 ford f450 remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=96726
Printed Date: May 10, 2025 at 1:51 AM
Topic: 2008 ford f450 remote start
Posted By: dereck
Subject: 2008 ford f450 remote start
Date Posted: August 28, 2007 at 9:27 PM
Hi i am looking for a wiring diagram for a 2008 ford f450 remote start and if the is a security system that i need to bypass for the ignition Thanks.
Replies:
Posted By: mauri197
Date Posted: August 29, 2007 at 11:07 PM
12volts | blue/red (x2)(common 20A) | + | ignition harness | Starter | blue/white | + | ignition harness | Second Starter | N/A | | | Ignition | WHITE/ orange | + | ignition harness | Second Ignition | N/A | | | Third Ignition | N/A | | | Accessory | BROWN / yellow | + | ignition harness | Second Accessory | PURPLE / green | + | ignition harness | Keysense | blue/lt. gray | + | ignition harness | Power Lock | blue/lt. green | - | driver kick, door harness | Power Unlock | yellow/purple | - | driver kick, door harness | Lock Motor | | | | Unlock Motor | PURPLE / gray | 5wi | driver kick, door harness | Parking Lights+ | PURPLE / white | + | SJB, conn. D, pin 20 | Notes: The SJB (Smart Junction Box) is in the passenger kick panel. | Parking Lights- | gray | - | headlight switch | Notes: When using the negative parking lights at the switch it is necessary to break the ground wire of the switch with a relay. See DirectFax document 1096 for wiring information. | Hazards | | | | Turn Signal(L) | | | | Turn Signal(R) | | | | Reverse Light | GREEN/ brown | + | harness to rear | Door Trigger | see notes | - | each kick or SJB, conn. C | Notes: The individual door trigger wires rest at ground and go to an open circuit when the doors are opened. The LF door is GREEN/ purple in pin 14. The RF door is white in pin 2. The LR door is green in pin 3. The RR door is yellow in pin 15.
The SJB (Smart Junction Box) is in the passenger kick panel. | Dome Supervision | yellow/gray | + | SJB, conn. A | Notes: The SJB (Smart Junction Box) is in the passenger kick panel. | Trunk/Hatch Pin | | | | Hood Pin | | | | Trunk/Hatch Release | | | | Power Sliding Door | | | | Factory Alarm Arm | | | | Factory Alarm Disarm | | | | Disarm No Unlock | | | | Tachometer | blue/white | ac | PCM or Customer Access Point | Notes: The Customer Access Point is above the driver kick panel. | Wait to start | see DirectFax document 1091 | | | Brake Wire | PURPLE / white | + | brake pedal switch | Parking Brake | WHITE/ purple | - | switch or SJB, conn. C, pin 1 | Notes: The SJB (Smart Junction Box) is in the passenger kick panel. | Horn Trigger | yellow/red | - | horn switch | Memory Seat 1 | PURPLE / white | - | driver kick, door harness | Memory Seat 2 | yellow | - | driver kick, door harness | Memory Seat 3 | | - | |
Interface Module: | Category: Immobilizer Bypass | Required: Yes | Type: SecuriLock | Part #: XK04 | Alternate Part1 #: 1100F/1100X | Alternate Part2 #: 556SW | Alternate Part3 #: 556UW | Alternate Part4 #: DesignTech 20402 | Alternate Part5 #: DesignTech 29402 | Notes: Standard on FX4, Lariat, and King Ranch models. Optional on the XL and XLT models. When using the 1100X, a software change to 1100FM is needed. |
Smart Starter Kill Relays: Not Available |
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. |
 |
|