viper 5000, ’89 s10 blazer

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=96825
Printed Date: May 15, 2025 at 6:11 PM

Topic: viper 5000, ’89 s10 blazer

Posted By: blznlw
Subject: viper 5000, ’89 s10 blazer
Date Posted: September 01, 2007 at 6:55 PM

Hey every one im new to this forum and im running around in circles trying to figure this out,,,,, i have a viper 5000 alarm system and im trying to make it pop my back window on my 89 s-10 blazer. Im using the red and white wire like is says in the install book but where im stuck is the red and white wire sends out a ground signal so when i hook it up to the relay like you normally would it doesnt do crap all? Any help would be great... thx josh

Replies:

Posted By: KarTuneMan
Date Posted: September 01, 2007 at 7:28 PM

Tell us how you wired your relay.... this is more than likely the issue.

Have you checked the output on the trigger from the alarm?

-------------

Posted By: blznlw
Date Posted: September 01, 2007 at 7:41 PM

well right after i made this post i saw the part on how to change the polarity on a realy, and as soon as i did that it worked liked a charm, so thans for the help posted_image

Posted By: blznlw
Date Posted: September 03, 2007 at 8:10 PM

So i was lookin on here and saw how to wire up the starter kill with a realy and it seemed really simple, but then when i grabbed my install guide for my alarm it showed a different way of doing it (i think).

posted_image
I used the basic starter kill on this site ( norm closed) as my guide.

So before i start cuttin and joining stuff, i wanted a bit of verification as to what i should do..... Thx

Print Page | Close Window