adding prox sensor to window module

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=96877
Printed Date: May 14, 2025 at 1:50 PM

Topic: adding prox sensor to window module

Posted By: timspa2
Subject: adding prox sensor to window module
Date Posted: September 04, 2007 at 1:37 AM

I have an Audiovox AX901 and i want to add a window module so I can roll the windows up with the auxillary on the remote but I would also like to have it wired to a motion sensor that will roll them up if triggered.Can I do this and what module and sensor should I use? Proper way to wire?

-------------
Tim

Replies:

Posted By: howie ll
Date Posted: September 04, 2007 at 3:52 AM

Surely if you arm the alarm this will raise the windows, therefore wiring the window closer through the motion sensor would be redundant and not needed. if you must, take the inner zone trigger wire from the sensor (assuming dual zone, if not the only trigger wire) to a timer such as DEI 908 set for for the length of time + 2 secs it takes to close the windows, use as a neg or pos output, depending on w/closer trigger polarity (you haven't told us what make) and feed this output to your window closer trigger.

Posted By: timspa2
Date Posted: September 04, 2007 at 8:55 AM

Sorry....90 Ford Bronco II and I wanted to wire it so I could leave the windows down when armed and use the proximity sensor to roll them up if triggered.

-------------
Tim