Print Page | Close Window

bypassing auto factory roll down switch

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=97059
Printed Date: July 12, 2025 at 10:47 AM


Topic: bypassing auto factory roll down switch

Posted By: ceasar326
Subject: bypassing auto factory roll down switch
Date Posted: September 11, 2007 at 4:47 PM

Ive recently installed a crimestopper CS-2014FM remote start and pager to a customer 98 lincoln navigator. Know im istalling window roll down modules, Autopage AC-78. For all four windows. I got both window modules hooked up. Everything works good but, when i activade aux 3 from alarm all windows go down except the driver door. I think that the auto factory window switch is not letting the driver roll down. Is there a way to bypass it or how would i wire it to make the driver door rool down? The module is a rool down when activade and rool up when arm. Wen arm all windows rool up. The only problem is rooling down the driver door any ideas?

Also he has one 6oo jensen hooked up as bass for a 10" kicker. Hes battery drains quick after playing 3 songs when the truck sits turned off. What would couse the battery to drain so quick? Is there a way to fix that problem? Any help would be much appreciated!




Replies:

Posted By: howie ll
Date Posted: September 11, 2007 at 5:06 PM
Go directly to driver  widow lift motor?




Posted By: init
Date Posted: September 11, 2007 at 6:03 PM
You'll need to take the door panel off to gain access to the wire.  You then need to connect in between the rolldown module and the factory motor.




Posted By: ceasar326
Date Posted: September 11, 2007 at 6:20 PM

All my wires i got from the main switch driver door panel! So i should get the wires from the driver side and not from the master switch?





Posted By: howie ll
Date Posted: September 11, 2007 at 6:33 PM
ignore the switch go directly to motor




Posted By: ceasar326
Date Posted: September 11, 2007 at 7:17 PM

ok thanks ill try going to the motor, ill let you guys know how it when.






Print Page | Close Window