04 f250 r.a.p

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=97210
Printed Date: May 12, 2025 at 4:43 AM

Topic: 04 f250 r.a.p

Posted By: 410440
Subject: 04 f250 r.a.p
Date Posted: September 17, 2007 at 7:23 PM

Customer has a 2004 F250, he remote starts the truck and if the starter times out and shuts off or he shuts the truck off his radio will stay on and play, i know there is a way to trigger the rap shutdown but i cant remember what it was?

Pulse the doorpin?

do you need a relay or will the (-) Rearm work and just send it to the doorpins?

-------------
Matthew Robertson
Senior Installer
Best Buy Deerfoot Meadows
Calgary, AB, Canada

Replies:

Posted By: profuse007
Date Posted: September 17, 2007 at 9:04 PM

you can use either or couple of diodes or a relay.

1)interrupt the door pin wire w/ the door trigger input(from alarm) one side going toward the door and the other side of the relay has the rearm wire attached.

2)blocking diode is prolly an easier choice. the point of using diode is to prevent the rearm feed from goin to the door trigger input wire, potentially setting off the alarm.

-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Posted By: wrenches
Date Posted: September 17, 2007 at 9:04 PM

Yes, that should work out fine. Just puse a doorpin with the rearm wire.

Posted By: KarTuneMan
Date Posted: September 17, 2007 at 11:53 PM

Depending on what type of unit is installed (post it on the next go around) there might be an output that is called "pulse after shut down" this would be used to pulse the drivers door pin wire.

This would be used, or could be used, instead of the rearm, IN CASE you need to actually rearm some factory security. Does this make sence? That way the radio is just shut off after the runtime, if nothing needed to be

"armed" Does is still make sence? if not..... never mind. posted_image

-------------

Posted By: 410440
Date Posted: September 18, 2007 at 10:59 AM

Its a command start cs595i starter / alarm combo

-------------
Matthew Robertson
Senior Installer
Best Buy Deerfoot Meadows
Calgary, AB, Canada

Print Page | Close Window