Print Page | Close Window

clifford’s lcd remote

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=97235
Printed Date: May 15, 2025 at 2:42 PM


Topic: clifford’s lcd remote

Posted By: adrosa
Subject: clifford’s lcd remote
Date Posted: September 18, 2007 at 7:25 PM

Hi,

I have recently got a Clifford Matrix 12.5X installed in my car. I added a Glass breakage sensor (let me call this GBS in this post) and connected that to one of  the available auxillary sensor inputs. I noticed that whenever the GBS trips, it gets reported as a Zone 4 alarm in the LCD remote and the Glass Breakage icon does not illuminate. I understand that Auxillary input 4 triggers might be needed to be programmed in the LCD remote to flash the Glass Breakage icon. If my understanding is correct. Would anyone be able tell me how to do it or at least tell me that making an Auxially input flash a certain icon in the LCD remote is futile.

Thanks a bunch.




Replies:

Posted By: captainzab
Date Posted: September 18, 2007 at 8:14 PM
getting the glass break sensor to display as zone 4 on your remote requires the bitwriter. (not possible to program by hand)
take it to the shop, they should have done that when they hooked up your alarm

-------------
Note: You Always Dont Get What You Pay For.




Print Page | Close Window