’03 ford explorer keyless entry problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=97515
Printed Date: May 15, 2025 at 3:22 PM

Topic: ’03 ford explorer keyless entry problem

Posted By: tuned97
Subject: ’03 ford explorer keyless entry problem
Date Posted: September 28, 2007 at 6:30 PM

I am trying to install keyless entry on my explorer and can't get the door locks to work. I'm installing a DEI Valet 711T which has relays for door locks. Supposedly it has a reverse polarity locking system. I checked the pink / YELLOW wire (lock wire) in the kick panel and it shows 12V at rest and ground when I hit the lock button. I tried hooking it up how it showed in the DEI manual for reverse polarity locks and nothing. Can someone please help?

Replies:

Posted By: kola7126
Date Posted: September 28, 2007 at 7:13 PM

POWER LOCK	PINK / YELLOW (TYPE B) See NOTE *2	IN DRIVERS KICK PANEL
POWER UNLOCK	PINK/LIGHT GREEN (TYPE B) See NOTE *2	IN DRIVERS KICK PANEL

On some vehicle with FACTORY ALARM or KEYLESS ENTRY, after the vehicle sets for a few minutes, if you cannot UNLOCK the door with the AFTERMARKET remote control it will be necessary to WAKE UP the GEM Module. See DIAGRAM, under DOOR UNLOCK, GEM WAKE UP DIAGRAM. IF the vehicle DOES NOT HAVE a FACTORY KEYLESS ENTRY or FACTORY ALARM it is a TYPE C Door Locking System.

Print Page | Close Window