Print Page | Close Window

connecting pkf 1 bypass module

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=97649
Printed Date: April 28, 2024 at 6:17 PM


Topic: connecting pkf 1 bypass module

Posted By: f150 guy
Subject: connecting pkf 1 bypass module
Date Posted: October 03, 2007 at 1:20 PM

Hi

I have searched the site and found many references to the pkf1 module, but I am confused as to where to connect the Tx and Rx wires. I have a 99 f150, and I am in the middle of putting in a commando ez-2500 remote starter. Any help in identifying and finding the correct wires would be greatly appreciated.




Replies:

Posted By: captainzab
Date Posted: October 03, 2007 at 2:54 PM
somewhere at the bottom right of the panel, 4pin harness. (trace the key cylinder down til you find it)
you MUST connect the Red wire of the PKF1 to the cars ignition at the PATS connector. i would also recommend using the ground there too.
install manual for PKF1
Your connector is type A.

One of the easiest bypass to use and program.

-------------
Note: You Always Dont Get What You Pay For.




Print Page | Close Window