Print Page | Close Window

2005 chysler 300m keyless entry programin

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=97890
Printed Date: May 14, 2025 at 2:17 PM


Topic: 2005 chysler 300m keyless entry programin

Posted By: duallyit
Subject: 2005 chysler 300m keyless entry programin
Date Posted: October 11, 2007 at 4:12 PM

i was curious to know if any one out their has the direction on to program a 2005 chysler 300m keyless entry remote? i have bought one off a friend and i tried to look every were on the net and no one has it? please help!

jb



-------------
DUALLYIT



Replies:

Posted By: usabuilt
Date Posted: October 11, 2007 at 4:45 PM
Try this,

Firstly you MUST have at one working transmitter.

1. reprogram all remote transmitters..any exsisting transmitters will be lost.

2 Turn ign. to on..
3. using your working transmitter press and hold unlock button.
4. after holding unlock button for at least 4 seconds but no longer than 10, press remote transmitter panic button for at least 1 second then release,
5. Ensure acoustic signal is emitted indicating Programming mode active.
6. Within 30 seconds (including previously programmed remote transmitter).
Press and hold remote transmitter lock and unlock button at the same time for 3 seconds,
7.Press and release remote transmitter unlock button.
8.Ensure acoustic signal is emitted after each remote transmitter operation.
9.Switch ignition off or wait 32 seconds to exit programming mode.
10. Ensure final acoustic signal is emmited..

******a maximum of 4 transmitters can be programmed.

Its listed to work on a 2004 model chrysler 300M..but it may work on a 2005 also..good luck


Print Page | Close Window