ultrastart 1270tl
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=98001
Printed Date: May 12, 2025 at 9:45 PM
Topic: ultrastart 1270tl
Posted By: ziggyb222
Subject: ultrastart 1270tl
Date Posted: October 15, 2007 at 7:50 PM
Started to install my first Ultrastart the other day. I have been doing crimestopper for the past couple of years. I got everything hooked up and soldered. Went into the tach set up and all went well. The unit confirmed the tach setting. Hit the start button and nothing happens. I tried to reprogram the transmitters and they would not confime they where done. Locks and everything do not function at all.. Any little trick I might be missing on programming the transmitters????
Replies:
Posted By: KarTuneMan
Date Posted: October 15, 2007 at 8:15 PM
More info please.....my e.s.p. skills are slipping. Year make and model of your car -------------
Posted By: ziggyb222
Date Posted: October 16, 2007 at 3:16 AM
It is an 05 Ford Five hundred. Had a Crimestopper piece of crap starter in it. Replaced it with this Ultra... Unit just seems non responsive like the transmitters are not programed.....
Posted By: xtremej
Date Posted: October 16, 2007 at 12:28 PM
When you try to start it are the pking lights flashing, how many blinks do you get? If not make sure you don't have it in service mode, indicated by the leds on solid (antenna)
Posted By: ziggyb222
Date Posted: October 16, 2007 at 1:14 PM
I have taken it n and out of service mode.. no leds on now.. and there doesnt seem to be any diagnostic codes in the memory because I get no flashes on the leds. I had left the fuse out of the parklights because I wanted to make sure i programmed the right polarity, i cannot imagine that being an issue, I hear the relay activate when I am changing program modes... These units are just new to me as far as programming goes... I need to get more time to work with these.. Thanks for your help by the way.....
Posted By: xtremej
Date Posted: October 16, 2007 at 1:18 PM
the RED / white doubles as either trunk release or negative trigger parking lights. white wire with fuse is only postive trigger.
Posted By: xtremej
Date Posted: October 16, 2007 at 1:18 PM
It is remote starting now?
Posted By: ziggyb222
Date Posted: October 16, 2007 at 1:23 PM
I will get the vehicle back soon... Will double check the parklights....
Posted By: JWorm
Date Posted: October 16, 2007 at 7:23 PM
Sounds to me like the remotes need to be programmed.
And about your comment about leaving the fuse out of the parking light wire....
The white wire will always be a (+) output, and the RED / white wire will always be a (-) output. The programming option your are referring to is the function that each wire controls. By default white is parking light, and RED / white is trunk release. After you change the programming the white is trunk release, and RED / white is parking lights.
|