power locks
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=98087
Printed Date: April 28, 2024 at 7:54 AM
Topic: power locks
Posted By: motormadman617
Subject: power locks
Date Posted: September 30, 2007 at 9:24 PM
This is what it says on the side of a Hornet 730T. -/+ door lock. Dose this mean it is connected to the + or - no difference? Thanks for educating me and your time.
-------------
Move It! Or Loose It!
Replies:
Posted By: rudydapimp
Date Posted: September 30, 2007 at 10:09 PM
yep, it will work on either without extra relays.
Posted By: motormadman617
Date Posted: October 18, 2007 at 5:51 PM
The alarm has a 3 pin output for locks.I would like to use this to add locks but don't know what plugs into it. Is it a plug from a universal kit.2ground lock/unlock and positive. I would love to wire as minimal as possible meaning if a 3 wire actuator can be wired directly without a CPU of a kit tell me so. If I need to use a door lock module because of the use of a 5 wire actuator thats cool too, just let me know what has to be done. Thanks buddy
-------------
Move It! Or Loose It!
Posted By: perly
Date Posted: October 19, 2007 at 11:50 AM
usually all DEI products(in my experience anyways) come with all req harnesses. Therefore the 3 pin harness that you are talking about is a GREEN/ blue and one other color which plugs into the brain. i am assuming that this is the harness which you are talking about since it is the only lock/unlock harness which I believe DEI uses. That being said if you do not have the harness then adding locks is pretty much impossible so try and find it or talk to a local shop because they might have some kicking around.
Now as far as hooking them up if you do not already have power locks in the vehicle you will need to buy aftermarket actuators --> you will need to use relays to power the actuators since the brain does not put out enough. If you already have power locks in the car then just hook up the green and blue to the proper wires(look in the manual to figure out which wire does what in which polarity)
You should also only need to use 2 wires(the blue and the green) the third is not needed. Blue and green are your locks/unlocks(either pos lock/unlock or neg lock/unlock) Just follow the 5-wire actuator diagram on the site to help you out.
Posted By: howie ll
Date Posted: October 19, 2007 at 1:43 PM
Blue is + to lock and - to unlock Green is - to lock and - to unlock These are VERY LOW Current outputs and you will need DEI 451 plug in relay module to control lock solenoids.
|