07 charger trunk release
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=98209
Printed Date: May 24, 2024 at 2:27 AM
Topic: 07 charger trunk release
Posted By: emorse2323
Subject: 07 charger trunk release
Date Posted: October 22, 2007 at 1:51 PM
I installed a aftermarket amp to the factory deck in a 2007 dodge charger and after I was done the truck release didn't work anymore any suggestions??
Replies:
Posted By: Twelvoltz
Date Posted: October 22, 2007 at 2:28 PM
The obvious things would be making sure you didn't pinch a wire, short anything out, unplug anything and forget to plug it back in.
I have first hand experience with an 06 Charger that the passenger rear window would not roll down in anymore shortly after I installed a remote start (lock/lock no less).
It had nothing to do with the remote start but the dealer insisted it did. I removed the system completely then they took the car back to the dealer, the dealer replaced the control module (not sure which) under warranty and I re-installed the starter with no further problems. It is possible it is just bad timing/luck.
-------------
Installer, IT support, and FFL. I need less hobbies.
Posted By: emorse2323
Date Posted: October 22, 2007 at 2:33 PM
Well Im thinking its a fuse but when i look in the book there is no fuse marked for the trunk release do you happen to know which one it could be?
Posted By: Twelvoltz
Date Posted: October 22, 2007 at 3:10 PM
What makes you think it would be a fuse? Did something short?
Test all of the fuses it only takes a couple of seconds to test them. Hook your DMM black lead to ground, and probe each end of the fuse. If you get a fuse that has +12V on one side and nothing/ground on the other side the fuse is blown.
-------------
Installer, IT support, and FFL. I need less hobbies.
|