honda civic 530t , clifford matrix 12.5x
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=98345
Printed Date: May 11, 2024 at 5:37 AM
Topic: honda civic 530t , clifford matrix 12.5x
Posted By: mechanix
Subject: honda civic 530t , clifford matrix 12.5x
Date Posted: October 26, 2007 at 1:29 PM
Hello everyone, I’m installing a 530T with a Clifford Matrix 12.5x into a ‘98 Honda Civic. I know, at least I think I know, which wires to splice for the up and down functions. However I am not sure what wires on the alarm I should connect the 530T wires to. I would like the windows to roll up when armed, and to roll down and vent with a press of the button. Thank you.
Replies:
Posted By: Twelvoltz
Date Posted: October 27, 2007 at 2:57 PM
Orange H1/12 Ground when armed to Orange H2/4 on your 530T. This will roll the windows up when armed.
There are a couple of wires that you could use to trigger the roll down but I would use the H2/4 Gray/Black channel 6 output. This output is active as long as you hold the button down. Press and release the button and the windows vent, hold the button the windows roll all the way down.
-------------
Installer, IT support, and FFL. I need less hobbies.
Posted By: mechanix
Date Posted: October 28, 2007 at 4:15 PM
Thank you very much for the info. Do I need a relay connected to the channel 6 wire? Thanks again.
Posted By: Twelvoltz
Date Posted: October 29, 2007 at 9:07 AM
There should be no need to add a relay as the inputs require a low current negative.
-------------
Installer, IT support, and FFL. I need less hobbies.
|