1998 prelude immobilizer, door trigger
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=98507
Printed Date: May 04, 2024 at 4:33 AM
Topic: 1998 prelude immobilizer, door trigger
Posted By: ftaudio
Subject: 1998 prelude immobilizer, door trigger
Date Posted: October 31, 2007 at 11:20 PM
i have the 555d immobilizer bypass and the wire colors listed do not match the colors in the car. if anyone has the right colors and a good diagram to work with let me know. i'm also having a problem with the door trigger, i have the autopage oled1000, should i used the possitive or negative trigger wire.
thanx
Replies:
Posted By: KarTuneMan
Date Posted: November 10, 2007 at 7:06 PM
Door pins and trunk pin are negative. | DOORPIN | WHITE/ black | In driver's kickpanel | - | | TRUNK PIN | Orange | In driver's kickpanel | - |
What colors don't match what colors?
Posted By: phonymike
Date Posted: November 11, 2007 at 7:30 PM
I put a 555d in my 01 prelude. I put the module behind the gauge cluster, and ran the wires down. there's a little module under the steering wheel, the wires are covered by a tube that looks like unshrunken heat shrink. I was able to run the bypass wires down that tube, cut the middle of the tube and make my connections there. you don't see the yel/blk, brn/yel, grey, and light blue wires? I got the honda manual, but I'm pretty sure the colors are the same, you might be looking in the wrong place. also I grabbed the key sense from the driver's kick so no wires were running to the steering column. but when I remote start my car, the immobilizer light (a green one) stays on, so I removed the bulb because the car works fine.
|