07 impala passkey 3 bypass
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=98550
Printed Date: April 27, 2024 at 9:10 PM
Topic: 07 impala passkey 3 bypass
Posted By: lysakjm
Subject: 07 impala passkey 3 bypass
Date Posted: November 02, 2007 at 10:02 AM
Anybody tried bypassing this system with the wire magic diagram. It uses 2 relays to byass the passlock system an one relay to wire wrap the key and bypass the passkey 3. I've done many homemade key wire wrap bypasses (dodge, honda, toyota, ford, GM PK3) but this new key on this model doesn't seem to send the signal up to the Ign. cyl. very good. Sometimes it starts and stays running and sometimes it will start and stall. I'm told if the passlock wasn't bypassing it woudn't even crank over and if the passkey is not bypassing the car starts and stalls. Any ideas?
Replies:
Posted By: lysakjm
Date Posted: November 05, 2007 at 12:47 PM
How about this question. Has anybody successfully used a DEI 556U on this car? Just want to know before I go out and buy one. Thanks
Posted By: Twelvoltz
Date Posted: November 05, 2007 at 1:08 PM
My recommendation: PKUGM2X------------- Installer, IT support, and FFL. I need less hobbies.
Posted By: rudydapimp
Date Posted: November 06, 2007 at 6:27 AM
I just did one with the CAN-SL2. wonderful bypass. does tach, door triggers, locks, everything!!!
Posted By: Mike M2
Date Posted: November 06, 2007 at 6:40 AM
I've used the 556uw in a new impala and it worked fine. We use them on all PK3 cars and trucks....
-------------
Mike M2
Tech Manager
CS Dealer Services
|