Print Page | Close Window

Shock & Radar Sensor at same time?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=9869
Printed Date: September 10, 2025 at 11:49 AM


Topic: Shock & Radar Sensor at same time?

Posted By: N1njaTurt1e
Subject: Shock & Radar Sensor at same time?
Date Posted: February 21, 2003 at 7:32 PM

I just got a new alarm, an UNGO ms2007, and I was wandering if it was possible to have both the shock sensor and a radar sensor installed at the same time? If so how hard would it be to accomplish this feat?



Replies:

Posted By: Two_Cold
Date Posted: February 21, 2003 at 8:58 PM
Super simple to do. Just splice them together and use a diode to isolate the trigger outputs.

I just learned that from a post by Velocity Motors.

In the past I have not used the diode with no problems. However from reading through some posts here I have discovered that the diode should be used to prevent false alarms and damage to the other spliced in device.



Posted By: N1njaTurt1e
Date Posted: February 21, 2003 at 9:14 PM
Cool, doesnt sound too bad. Thanks for the info!!


Print Page | Close Window