Print Page | Close Window

ford gem wake up 2001 ford explorere

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=9871
Printed Date: October 31, 2024 at 6:07 PM


Topic: ford gem wake up 2001 ford explorere

Posted By: mobiletoys2002
Subject: ford gem wake up 2001 ford explorere
Date Posted: February 21, 2003 at 8:46 PM

Where is the factory disarm wire at in this vehicle and how do i wake up the gem? i am adding a remote start and alarm.the vehicle is a 2001 ford explorer. Also can i catch a tach wire inside the vehicle?? Thanks for the info



Replies:

Posted By: Velocity Motors
Date Posted: February 22, 2003 at 7:27 AM
OEM Alarm DISARM is at the drivers kick panel DARK GREEN/ PURPLE..For the GEM wake up diagram go to my website and look up the Ford section for DIY and there's a link to the GEM wake Up Diagram there. Good luck.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: bianchina3
Date Posted: February 22, 2003 at 5:09 PM
I've got the same problem and I can't find the correct wire. In fact I hate to admit it, but I don't know what is meant by the kick panel? I've taken the drivers door off but can't find the wire there so I assume that thats not the kick panel. next I took off the panel under the dash by the emergency brake but there were no wires there. I am confused.

-------------
Ed




Posted By: Velocity Motors
Date Posted: February 22, 2003 at 5:40 PM
The kick panel is the plastic piece that covers the side of the lower foot area by the emergency foot brake.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: BNLUIS
Date Posted: February 22, 2003 at 9:02 PM

 Pulse the unlock wire and disarm wire at the sametime and program your alarm to double pulse. This way the first pulse will wake-up the GEM and the second pulse will unlock doors. This should help.

P.S. use diodes to isolate wires.



-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.





Print Page | Close Window