99 yukon Viper Install

I have a few questions on my install(1st time installer):Yukon 4 Door: Viper 790XV

1.On my PLDATA can the gwr be activated by this from my alarm: This wire (H3/1)(-) supplies a 200ma output as soon as the module begins the remote start process.

2.How do I hook up my neutral safety input on my alarm?

3.What is the Lock Motor/ Unlock Motor used for on the Yukon wire list?

4. On the door locks I wired my alarm Lock/Unlock to lt blue/white is the used just to activate the relay becasue I know my alarm can only drive a relay and not the full load of all the locks?

5. I am confused on how to hook my (-) 200 ma domelight supervision wire, it shows the use of a dbdt with the following connections 85-input from alarm, 86-12 volts, 87 domelight supervision +or- (white underdash??),and 30 shows domelight supervision wire( unsure of what this wire is)

Any help would be greatly appreciated

Thanks
Ben



-------------
evilways

2-the netral safety switch can be connected to ground in most vehicles if the car cannot start while in gears other than park and netral.
3-these would be used for driver door priority unlocking but not always used.
4- the 4 door versions of this vehicle and they are positive pulse which the way you describe would be correct. if ir is a 2 door then you have a 5 wire set up and then you would need 2 relays wired in a reversed polarity configuration which the diagram for this is on this site.
5- you have a negative dome light wire at the light under dash this wire is the wire that will conect to pin 30 of the relay, and pin 87 will be a ground pin 85 will go to the BLACK/ white wire off the viper and pin 86 is positive 12 volts.

Here's an easy to follow diagram for your domelight relay.

I have a small Security FAQ on my site with more info and diagrams.

Security FAQ




-------------
Viper Equipped