remote start with factory alarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=98754
Printed Date: May 20, 2025 at 1:11 AM
Topic: remote start with factory alarm
Posted By: zeus_r6
Subject: remote start with factory alarm
Date Posted: November 08, 2007 at 12:14 AM
About to install a remote start/keyless, and would like to use the arm/disarm outputs on the remote start to work with the factory alarm...any input on this?
Replies:
Posted By: zeus_r6
Date Posted: November 08, 2007 at 12:15 AM
Forgot to mention it's on an 06 Mark LT
Posted By: techman93
Date Posted: November 08, 2007 at 10:10 PM
Audiovox site says factory alarm arms and disarms with lock/unlock.
Posted By: Twelvoltz
Date Posted: November 09, 2007 at 7:35 AM
Are you sure it has a factory alarm? I have done a few of the full size Ford trucks and have yet to see one with an alarm. To check, with the driver's door open roll down the driver's window, press lock on the door panel and close the door. Wait 2 minutes then reach in through the window and open the door using the inside handle. If your alarm goes off then you know you have one, unlock the door with a key to disarm the alarm or press unlock on the remote. If it does not sound the horn you do not have a factory alarm. Yes you have a panic button on the remote but not a content anti-theft system.
-------------
Installer, IT support, and FFL. I need less hobbies.
|