viper 5900, 00 dodge ram 3500 diesel

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=98755
Printed Date: May 19, 2025 at 7:57 PM

Topic: viper 5900, 00 dodge ram 3500 diesel

Posted By: morg769
Subject: viper 5900, 00 dodge ram 3500 diesel
Date Posted: November 07, 2007 at 4:40 AM

2000 Dodge Ram 3500 Diesel

Installing a Viper 5900 SST and need to know where the WHITE/ blue wire remote start (-) activation input connects to or if it is used. Plug H1/10.

Replies:

Posted By: techman93
Date Posted: November 07, 2007 at 6:35 AM

It doesn't get connected. It is for activating the remote start from another source.

Posted By: morg769
Date Posted: November 08, 2007 at 1:43 AM

Can anyone give me the the relay satellite wire connection for a Viper 5900. Being installed in a 2000 Dodge Ram 3500 Diesel.

Purple I think it is Start output and go's to the yellow wire

Green I think it is starter input what wire will it connect to?

Red +12V to Red or pink/black

Orange + Accessory output to BLACK/ orange

Pink+ ignition output to Dk. Blue

Pink/white not used

RED / white is it used?

Posted By: Twelvoltz
Date Posted: November 08, 2007 at 7:07 AM

RED / White is necessary. The manual has not been updated to reflect that the RED / White is not jumpered at the relay pack anymore. Just connect it to either the red or pink/black with one of the reds.

Green and Purple are both part of the starter wire circuit. Cut your yellow wire in the vehicle and connect the green to the key side of the cut wire and the purple to the vehicle side of the cut yellow. This will provide you with both starter kill and anti-grind.

Pink/White probably will not be needed. I have come across some Dodge's that are picky and needed the second accessory powered. If for some reason the Check Engine light comes on or the A/C compressor or blower motor does not energize during remote start hook the pink/white to the BLACK/ white second accessory and program it to be an accessory output via the programming menu.

-------------
Installer, IT support, and FFL. I need less hobbies.

Posted By: extreme1
Date Posted: November 08, 2007 at 4:55 PM

IF YOU'RE NOt using the 2nd ign (pink/white) then the RED / white wire doesn't need to be hooked up.

-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta

Posted By: 33up
Date Posted: November 10, 2007 at 5:53 AM

So if the Pink/White 200mA from the 7 wire ribbon is programmed to be an accessory trigger then the heavy gauge remote start relay Pink/White 2nd ignition output will become a 2nd accessory output?

Posted By: extreme1
Date Posted: November 10, 2007 at 11:10 AM

yes, however I've never needed to hook up second acc in those trucks ever.

-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta