adjusting paging feature viper

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=99014
Printed Date: May 11, 2024 at 11:04 AM

Topic: adjusting paging feature viper

Posted By: bmwsteve
Subject: adjusting paging feature viper
Date Posted: November 14, 2007 at 8:52 PM

1997 BMW M3-
Viper 5900 (same as 791xv mostly) Dual Zone Proximity Sensor Attached. I have a system with a two way remote. I checked online, searched this forum, and the manual, and I can't seem to find the answer.

Every time the proximity sensor send its "warn" siren, (few short beeps to let you know you are too close) it send a page to my alarm remote. I want it to only send that page if the alarm actually goes off. I personally don't like proximity sensors, but is necessary in my situation, but every time someone with base or exhaust goes off, it pages the alarm, and its getting really annoying. I only want it to page me if the alarm actually starts going off. Is this possible on this alarm?

Thanks in advance!

Steve

Replies:

Posted By: hydrodancer91
Date Posted: November 14, 2007 at 9:13 PM

the only way it is possible is if you disconnect the warn away from the prox. other than that it will page you just like it was the shock sensor going off.

Posted By: bmwsteve
Date Posted: November 14, 2007 at 9:26 PM

hydrodancer91 wrote:

the only way it is possible is if you disconnect the warn away from the prox. other than that it will page you just like it was the shock sensor going off.

Is that a particular wire on the prox sensor? if so, what color. If I do that, wont it stop the warn away completely? like the siren on the car wont warn either?