programming dei alarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=99107
Printed Date: April 26, 2024 at 9:21 PM
Topic: programming dei alarm
Posted By: bondo-boy
Subject: programming dei alarm
Date Posted: November 17, 2007 at 6:03 PM
how do you program setting from default to two-chirp setting,tried to do tach-less and voltage sense but cant seem to get it , any help?
Replies:
Posted By: eurobink
Date Posted: November 17, 2007 at 6:36 PM
open door, key on/off hold valet till chirps once, keep holding till chirps twice, keep holding till chirps 3x. push the valet 3x and hold. then push unlock button on remote. let go of valet. cycle ignition and you are done.
Posted By: offroadzj
Date Posted: November 17, 2007 at 6:38 PM
are you programming using the button and led, or bitwriter? If you are using hte button, then once you get to the feature that you want to change, press the ch. 2 button on the remote (usually unlock..except for the 3button remotes, it is the aux button)
HTH
Well i was beat to it, but as a note, if you are using voltage sense, you might as well change the crank time to atleast the .8sec timing. I have seen very few cars that will actually start at the default .6 sec.
-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205
Posted By: eurobink
Date Posted: November 17, 2007 at 7:44 PM
all new cars i have done with .8 over-crank.. i prefer to let the unit try to restart than burn the starter, older vehicles i would definitely do .8
Posted By: offroadzj
Date Posted: November 17, 2007 at 7:57 PM
most newer cars dont need the .8... but I usually use .8 for most late 90s, early 2000's and then have them come back for an increase if needed.
-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205
|