nu1000r reprograming
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=99223
Printed Date: May 15, 2024 at 2:10 PM
Topic: nu1000r reprograming
Posted By: rugmuncher07
Subject: nu1000r reprograming
Date Posted: November 21, 2007 at 1:37 PM
Hello, Looking to reprogram Nustart Nu1000R after the battery has being disconnected. Had it installed out of town and it is very difficult to get in right now, they won`t tell me the prcedure for doning so. Thanks!
Replies:
Posted By: moonliter
Date Posted: November 21, 2007 at 2:18 PM
If you meant the remote, then turn the ignition on and off 5 times (between acc & on) with the car key within 7 seconds. the parking lights will flash once. press the lock button for 1/2 sec. parking lights will flash once to confirm that the remote has been programmed. If the main module lost the tach, then start the car and let the engine idle down. Press the tach learn button at the opposite side of the main harness of the module. the siren will chirp once to confirm that the tach has learned.
Posted By: rugmuncher07
Date Posted: November 21, 2007 at 6:06 PM
Thank you for the reply.... The steps you mentioned are right from the manual I have. I had the battery disconnected and now it won`t work. I have tried that procedure over and over and I get nothing. The place that installed it said it would take approx. 20 minutes to reprogram it. ???
Posted By: moonliter
Date Posted: November 21, 2007 at 7:49 PM
Be Descriptive and Specific Providing more information makes it easier for everyone else to help you. Like year, make and model of your vehicle, gas or diesel, auto or manual transmission, remote starter, alarm or rs/alarm. with or without power door locks. What exactly is the problem and why you think it needs to reprogram ?
Posted By: rugmuncher07
Date Posted: November 21, 2007 at 8:40 PM
1990 Pontiac Tempest, Gas, Automatic, remote starter, with power windows, locks and trunk release. Battery was disconnected. When starter, lock, hood release is pressed it does nothing. Light on key phobe light uip, but nothing beyond that. I had a simlilar problem before but I never disconnected the battery and they replaced the brain unit once. I was told by installer "did you disconnect battery" and I told them "yes" They told me to bring it in to be reprogramed and it would take apporx. 20 minutes, Any more details? I have to drive an hour out of town and might not even beable to get in to get it fixed.
Posted By: moonliter
Date Posted: November 21, 2007 at 9:02 PM
I believed some of the nustart r/s had a history of defects. I will pm you some info, call the person in charge of warranty/tech support not the place you got it installed. You properly could get a replacement. If possible get a compustar but not nustart. They are identical but different brand name.
|