99 f-150 remote start wiring

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=99311
Printed Date: May 12, 2025 at 5:05 AM

Topic: 99 f-150 remote start wiring

Posted By: maxcat
Subject: 99 f-150 remote start wiring
Date Posted: November 24, 2007 at 5:04 PM

Hey guys, I have a r/s to install into a 1999 ford f-150 and was wondering if anyone could tell me if the ign. harness is hard to access. Is it just the lower panel that needs to be removed to get to the ign. wires, and the steering column shroud to get to the data wires for the bypass. also could someone tell me the wire colors for the data tx and data rx for this vehicle. also with the 4.2 engine where is the best location to get the tach wire. any insight would be greatly appreciated.

thank-you in advance

Replies:

Posted By: KarTuneMan
Date Posted: November 24, 2007 at 5:48 PM

VSS WIRE

Gray/black

At Powertrain Control Module

8000ppm

Pin-68 on the F150 and F250, Pin-58 on the F250 and F350 Superduty. The PCM is located on the driver's side of the firewall.

TRANSPONDER IGNITION

RED / lt.green

In 4-pin plug on steering column

TRANSPONDER DATA 1

WHITE/ lt.green

In 4-pin plug on steering column

DATA

TRANSPONDER DATA 2

Gray/orange

In 4-pin plug on steering column

DATA

TRANSPONDER GROUND

BLACK/ lt.blue

In 4-pin plug on steering column

Posted By: maxcat
Date Posted: November 24, 2007 at 8:27 PM

Thanks, KarTuneMan, I appreciate the reply and the info