06 odyssey, remote starter
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=99439
Printed Date: July 12, 2025 at 5:33 PM
Topic: 06 odyssey, remote starter
Posted By: prdjr165
Subject: 06 odyssey, remote starter
Date Posted: November 28, 2007 at 1:00 PM
I installed a remote starter in this van and I connected the ign 2 wire from the remote start unit to the 2nd accy(WHITE/ red)wire,I forgot to move the jumper bar to make the ign 2 wire a 2nd accy wire,My question is do you think this will damage anything?.
Replies:
Posted By: Twelvoltz
Date Posted: November 28, 2007 at 1:12 PM
I would suggest moving the jumper to the proper position. Although it may not hurt anything the ignition supply circuit was not designed to power the accessory circuit while starting.
-------------
Installer, IT support, and FFL. I need less hobbies.
Posted By: moonliter
Date Posted: November 28, 2007 at 1:21 PM
It shouldn't have, but may cause the car hard to start if it draws too much current. acc2 is for for blower motor. acc's are turned off during start cycle, once the vehicle is started then acc's will come back on.
Posted By: prdjr165
Date Posted: November 29, 2007 at 9:04 AM
Thanks for the replies!I will have to get the van back and switch the jumper or just dis-connect the wire completely because I've seen other sites that say that the second accy wire isn't needed.
|