2003 honda crv parking lights

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=99577
Printed Date: May 15, 2025 at 2:06 AM

Topic: 2003 honda crv parking lights

Posted By: bumpinaltima
Subject: 2003 honda crv parking lights
Date Posted: December 02, 2007 at 4:20 AM

Hello,

This is the first install that I'm doing. I just installed a bulldog system 500 remote car starter in my wife's car. I do not know how to hook up the parking lights? I have the two wires from the car, one in the green stock alarm plug which is the parking -, and one in the kick panal which is the parking positive. I'm not sure what one to use? Both? I also can only find two wires on the car starter marked Parking light relay output, and one marked parking light relay input. The input one is already connected in the harness to 12 volts, that was already done by the manufacturer. Any suggestions?

Thank you very much for any help you can give......

Replies:

Posted By: KarTuneMan
Date Posted: December 02, 2007 at 9:37 AM

Well input and output need to be the same. If you have the input hooked to 12v, you will need to attach the output to the (POS)+ parking light on the car.

If you needed (NEG)- parking lights.... you would change the input to ground..These 2 wires represent pins 87 (input), and pin 30 (output) of a standard relay.

Posted By: bumpinaltima
Date Posted: December 02, 2007 at 11:29 AM

+ that was it, all i needed was a little push. Thank you very much