98 nissan quest RMS

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=9975
Printed Date: August 21, 2025 at 2:27 PM

Topic: 98 nissan quest RMS

Posted By: asag20
Subject: 98 nissan quest RMS
Date Posted: February 23, 2003 at 9:21 PM

Hi, Guys,
i have install a code alarm starter in a 1998 Nissan Quest. 1, the car starts in the morning with difficulty. it starts & stops but it works fine during the afternoon. i could not locate the tach so i used the injector. is it the cause of this morning start & stops.
i also make sure the cold start wire is connected. anyone has any help for me thanks in advance. the wiring diagram will also help.

Replies:

Posted By: BNLUIS
Date Posted: February 24, 2003 at 12:00 PM

go straight to tach wire and learned to the starter.

98 nissan quest

TACHOMETER|green | |ign. module on engine

or try this

GRN/WHT (AC) IGN. MOD ON ENG.OR PCM PIN 3 GLOVE BOX

-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.

Posted By: djfearny2
Date Posted: February 24, 2003 at 1:25 PM

injector no good my friend will feedback and kill ecm......... go to tach or one of the coils never injector also that is a nissan it hass the second starter wire., use a rellay to connect to it dont just jump it , they are two different circuts for a reason. so go to coil or the tach never injector this is badd veryyyyy veryyyy bad . now that you know change to prevent future damage,.

-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.