08 outlander key sence

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=99899
Printed Date: May 18, 2025 at 3:20 AM

Topic: 08 outlander key sence

Posted By: azn_fcuk
Subject: 08 outlander key sence
Date Posted: December 11, 2007 at 6:33 PM

Well im having a nightmare with the keysence on this vehicle. Ive installed everything correct. All the tech data says RED / white open circuit. Now the wire tests neutral. As soon as i put my test light on the wire everything activates and it unlocks the sterring, when i cut the wire the vehicle starts, but i cant get it to do this when i put a ground, current, and resistor with either polarity the vehicle wont start..

Very odd vehicle, im really in a bind, help asap THANKS!

Replies:

Posted By: mobilefx
Date Posted: December 11, 2007 at 10:07 PM

u tried to use a relay? pin 87a to key side of keysence, pin 30 to car side of keysense pin 85 to ground when running from starter, and pin 86 to 12volts.

should open the wire w/ remote start is activated.

-------------
MOBILE F/X

Posted By: realsnake
Date Posted: December 11, 2007 at 10:18 PM

On the 2008 the keysense is a Light/Blue negative wire, if the vehicle fail to remote start when you trigger this wire using a (-) signal it's because the vehicle is attempting to knowledge the transponder when the keysense comes ON. If your transponder module is not ready to chanllenge the immobilizer, your remote start sequence will fail. the vehicle will still challenge the transponder upon ignition but chances to fail are drastically increasing.

Print Page | Close Window