2005 lancer non evo r/s, bypass?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=99921
Printed Date: October 28, 2025 at 7:20 PM
Topic: 2005 lancer non evo r/s, bypass?
Posted By: lsondubz
Subject: 2005 lancer non evo r/s, bypass?
Date Posted: December 12, 2007 at 7:49 AM
Have a 2005 Lancer basic model coming in for Remote Start/Keyless, I only can find the wiring diagram on here for the evo, but Ive read a few threads that say the regular Lancer might not need a bypass? Any help/info would be appreciated, thanks!
Replies:
Posted By: KarTuneMan
Date Posted: December 12, 2007 at 9:34 AM
Transponder.....YES. | PASSIVE ANTI-THEFT | YES | TRANSPONDER | SEE NOTES | | 12 VOLTS | White | Ignition switch harness | + | | IGNITION | BLACK/ white | Ignition switch harness | + | | ACCESSORY | Blue/black | Ignition switch harness | + | | STARTER | BLACK / YELLOW | Ignition switch harness | + | | KEY SENSE | Blue/red | Ignition switch harness | - | | | | This wire is ground with the key out and goes to an open circuit when the key is inserted. |
| | TACH SIGNAL | BLACK / YELLOW or BLACK/ green | At either of 2 coils on top of engine | AC | | CRANKSHAFT POSITION SENSOR | BROWN / green | On lower front of engine | | | | | Also found at pin-45 of connector C-118 connector of PCM behind glove box. |
| | FUEL INJECTOR | Opposite from RED / yellow | At any injector on engine | AC | | LOCK | Violet | On junction block above DKP | - | | UNLOCK | Lt.green | On junction block above DKP | - | | DOORPIN | Black or white | On junction block above DKP | - | | TRUNK PIN | GREEN/ orange | At light in luggage compartment | - | | FACTORY ARM | Arms with lock wire | | | | FACTORY DISARM | Gray | In driver's kickpanel | - | | BRAKESWITCH | Green | At switch above brake pedal | + | | PARKLIGHTS | GREEN / WHITE | On junction block above DKP | + | | HAND BRAKE | BLACK/ red | At switch on handbrake lever | - | | HORN | Blue/red | At steering column | - | | CLUTCH SWITCH | Blue/orange | At switch above clutch pedal | TYPE 4 | | DRIVER WINDOW UP | RED / black | At switch in driver's door | REV POL | | DRIVER WINDOW DOWN | GREEN/ black | At switch in driver's door | REV POL | | PASSENGER WINDOW UP | Blue/white | In driver's kickpanel | REV POL | | PASSENGER WINDOW DOWN | BLACK/ white | In driver's kickpanel | REV POL | | LEFT REAR WINDOW UP | White | In driver's kickpanel | REV POL | | LEFT REAR WINDOW DOWN | Blue | In driver's kickpanel | REV POL | | RIGHT REAR WINDOW UP | Blue/black | In driver's kickpanel | REV POL | | RIGHT REAR WINDOW DOWN | GREEN/ YELLOW | In driver's kickpanel | REV POL | | HEADLIGHTS | RED / black | On junction block above DKP | + | | REVERSE LIGHTS | Brown | Under driver's side running board | + | | VSS WIRE | BLACK / YELLOW | Pin-8 at PCM behind glovebox | |
-------------
Posted By: JWorm
Date Posted: December 12, 2007 at 12:40 PM
One the Evo has a transponder.
Posted By: lsondubz
Date Posted: December 12, 2007 at 4:48 PM
So yes or no to the transponder then lol
Posted By: enice
Date Posted: December 12, 2007 at 8:24 PM
i remember one of my buddies has a remote start in his and had a mess before i cleaned it up. It was an 2006 Lancer and no it did not have a transponder. If im not mistaken only evo editions do but then again just install it and just warn the customer that they MAY need to have a spare key. Pretty sure if the 06 didnt have it then the 05 wouldn't either.
Posted By: tedmond
Date Posted: December 12, 2007 at 9:48 PM
scytek says transponder is on the car. i double checked with fortin and the Lancer does have a PATS transponder system.
Posted By: KarTuneMan
Date Posted: December 12, 2007 at 11:25 PM
Canadian model just might....huh, think so?
-------------
Posted By: JWorm
Date Posted: December 12, 2007 at 11:54 PM
I don't have access to directechs anymore, but it always said "Evo model only" for transponder. I have worked on an Evo...it had a transponder. I have not worked on a regular Lancer. Otherwise, the wiring will be the same.
|