2005 camry door locks
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=99928
Printed Date: April 27, 2024 at 10:26 AM
Topic: 2005 camry door locks
Posted By: russ lund
Subject: 2005 camry door locks
Date Posted: December 12, 2007 at 10:34 AM
I just did an install on a 2005 Camry and all went well until I gave it to the customer.The door locks just fine but the R/S remote will not unlock.If I open the drivers door it will lock and unlock just fine. I think I had this problem on a Matrix but I can't remember what the hell I did. Thanks Russ.
-------------
BigDog
Replies:
Posted By: Twelvoltz
Date Posted: December 12, 2007 at 10:38 AM
Set the unit to double pulse unlock.
-------------
Installer, IT support, and FFL. I need less hobbies.
Posted By: russ lund
Date Posted: December 12, 2007 at 11:05 AM
Yeah I have set it to double pluse to no avail.
-------------
BigDog
Posted By: Chris Luongo
Date Posted: December 12, 2007 at 11:21 AM
Would help a lot if you mentioned the product you installed, and how/where you connected locks.
Posted By: OhioMike1101
Date Posted: December 12, 2007 at 11:33 AM
probably set up with the child locks
-------------
South Side Audio
2501 S. High St
Columbus, OH 43207
Posted By: russ lund
Date Posted: December 12, 2007 at 12:21 PM
Sorry gang.The unit is a scytek Galaxy 2000.I used the regular lock and un lock from the unit.The vehicle isn't set for child lock.
-------------
BigDog
Posted By: tedmond
Date Posted: December 12, 2007 at 2:25 PM
double pulse to unlock. the thing with camry is one pulse disarms the alarm and other pulse opens the locks.
Posted By: JWorm
Date Posted: December 12, 2007 at 2:28 PM
Did you use these wires for lock/unlock?
POWER LOCK BLUE / YELLOW (-B) See NOTE *2 IN DRIVERS KICK PANEL or 20-PIN PLUG, BOTTOM of FUSE BOX
POWER UNLOCK BLUE (-) See NOTE *2 (REQUIRES DOUBLE PULSE) IN DRIVERS KICK PANEL or BECU, TOP PLUG, PIN 22
NOTE *2 THE LOCK AND UNLOCK WIRES WILL ONLY TEST WHEN TURNING THE KEY IN THE DRIVERS DOOR KEY CYLINDER.
Posted By: russ lund
Date Posted: December 12, 2007 at 2:31 PM
There is no blue wire in that harness,I used the key in the drivers door to find the wires.But why does the lock and unlock work when the dorr is open?
-------------
BigDog
Posted By: tedmond
Date Posted: December 12, 2007 at 3:44 PM
Power Locks - Blue / YELLOW (-) located @ BOTTOM of DKP. Located in a 16 Pin BLUE connector.
Power Unlock - Blue (-) located @ DKP Third plug from the bottom. Located in a 20 Pin BLUE connector. not sure why the locks would not work when door is closed. make sure u connected everything properly and make sure u didnt snip any wires in the process.
Posted By: russ lund
Date Posted: December 12, 2007 at 4:32 PM
Thanks guy's I'll have the car back next week and try again,Russ
-------------
BigDog
Posted By: Chris Luongo
Date Posted: December 12, 2007 at 7:01 PM
The reason the double pulse doesn't help is because you're on the wrong wires.
In the driver's kick panel are a total of five plugs, two closer to the rear of the car, and three toward the front.
The three toward the front all come in from the driver's door........if you wiggle the boot in the door jamb while looking inside the kick panel, you will see.
Of those three plugs, the blue / YELLOW is in the bottom plug, and the blue is in the top.
And it's not really "double-pulse" like the tech sheet says........one pulse does the driver's door, and a second pulse does the other doors.
If you leave double pulse turned off, your customer should end up with two-stage unlocking, just like factory.
|