05 honda accord, viper 5002
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=99984
Printed Date: April 28, 2024 at 8:21 PM
Topic: 05 honda accord, viper 5002
Posted By: eeh1025
Subject: 05 honda accord, viper 5002
Date Posted: December 13, 2007 at 4:24 PM
Hi there i have an o5 honda accord coupe and im installing a viper 5002 system, my question is the door locks what type of system is it, and what wires do i hook up to,
thanks alot
Replies:
Posted By: tedmond
Date Posted: December 13, 2007 at 4:38 PM
honda door locks are Negative trigger or known as Type B Lock - Pink/Black (-) located under dash @ MICU*. Pin 25 in a Green plug
Unlock - Pink/Blue (-) located under dash @ MICU*. Pin 9 in a Green plug *MICU is part of underdash relayfuse box. The plugs are hard to get to since they sit on the left hand side edge. good luck
Posted By: eeh1025
Date Posted: December 13, 2007 at 5:19 PM
Hi there i have an 05 Honda Accord coupe, could you mount the unit behind the door panel,I mean you have your 12v constant 12v keyed door locks, etc. Would it hurt anything to mount it there?
Posted By: JWorm
Date Posted: December 13, 2007 at 5:47 PM
Do you have an EX or LX? This is one of the few cars where it makes a difference.
Posted By: eeh1025
Date Posted: December 13, 2007 at 5:56 PM
its is an EX
Posted By: tedmond
Date Posted: December 13, 2007 at 5:57 PM
umm i dont think thats the brightest idea. ur limited to space. plus u have to run wires back to the door molex to kick panel. doing that alone will kick u in th ebutt. it will take really long. just hide it up in ur dash and tape it up/loom it good. doesnt matter if u wired it and hid it, as long as the theif wants to cut the power to ur alarm, he will easily.
Posted By: howmuchlonger
Date Posted: December 13, 2007 at 6:50 PM
I wouldn't think about it. There is way too much moisture in the door.
-------------
Test it w/your meter!!!
Posted By: dre187
Date Posted: December 13, 2007 at 8:24 PM
everytime you close your door, you would be abusing the unit pretty bad too
Posted By: Chris Luongo
Date Posted: December 13, 2007 at 10:21 PM
I did that once in an older Civic.
It worked out perfectly, and the car never came back.
But, when I reached the point where I was halfway done, and it was too late to turn back, I started to regret it.......there were quite a few wires that had to be run back inside the car.
Posted By: howie ll
Date Posted: December 14, 2007 at 12:39 AM
Bit like climbing Everest :- 'cause it's there. If yu've got so much time, come and help me.
Posted By: 13 volts
Date Posted: December 14, 2007 at 1:11 PM
I have hid a compustar inside a gutted out subaru factory subwoofer box under the passenger seat. Never gonna do that again. Nobody wants to pay extra for that type of work.
Posted By: 97gss
Date Posted: December 14, 2007 at 4:21 PM
| Power Unlock | | PINK/BLUE | | (-) | | GREEN CONNECTOR, LEFT OF FUSE PANEL |
| PowerLock | | PINK/BLACK | | (-) | | GREEN CONNECTOR, LEFT SIDE OF FUSE PANEL |
Use passenger door switch to test
Posted By: eeh1025
Date Posted: December 14, 2007 at 4:40 PM
Hi guys i have an 05 honda accord coupe ex and i just installed a viper 5002 everthing works but not the unlock and lock, i hooked it using a negitive pulse i guess thats right if not could some please tell me what type i have and how to hook it up or a diagram
thanks alot
Posted By: tedmond
Date Posted: December 14, 2007 at 5:03 PM
if u have the proper wires with a negative pulse, it will work without a problem. it just might be that ur wires are wrong. Always check with a digital volt meter. the wires are located in my post on page 1.
Posted By: eeh1025
Date Posted: December 14, 2007 at 5:09 PM
heres how i have it i have the 2 fused purple wire connected to ground and i have the GREEN/ blk wire to the pink/blk lock, and i have the blue/blk wire to the pink/blue unlock
does that sound right
Posted By: eeh1025
Date Posted: December 15, 2007 at 1:08 AM
anybody i need help
Posted By: fiveohh
Date Posted: December 15, 2007 at 11:24 AM
eeh1025 wrote:
heres how i have it i have the 2 fused purple wire connected to ground and i have the GREEN/ blk wire to the pink/blk lock, and i have the blue/blk wire to the pink/blue unlock
does that sound right
Thant looks right to me, check them with a multimeter and make sure that they are the correct wires(on both the car and the brain).
|