06 jeep commander door locks
Printed From: the12volt.com
Forum Name: Relays
Forum Discription: Relay Diagrams, SPDT Relays, SPST Relays, DPDT Relays, Latching Relays, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101900
Printed Date: April 29, 2024 at 8:19 AM
Topic: 06 jeep commander door locks
Posted By: alansund
Subject: 06 jeep commander door locks
Date Posted: February 05, 2008 at 10:25 AM
I am installing a remote start on an 06 Jeep Commander and from what I have read I need to use relays to control the door lock. This is a single wire system needing a negative through a 330 ohm to lock and a negative through a 100 ohm resistor to unlock. If someone could tell me how to wire the relays I would appreciate it. Also, will I need anything other than the relays to make the locks work? Thank you for your help.
Replies:
Posted By: perly
Date Posted: February 05, 2008 at 11:13 AM
I would recommend the idatalink al ca and the c2 ring. This module will do locks, alarm, tach, starter and I believe that it also gives you doorpin outputs, horn and some more that I am missing. Using this you do not need any resistors or relays.
|