Print Page | Close Window

will this relay work?

Printed From: the12volt.com
Forum Name: Relays
Forum Discription: Relay Diagrams, SPDT Relays, SPST Relays, DPDT Relays, Latching Relays, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116545
Printed Date: May 15, 2025 at 6:20 PM


Topic: will this relay work?

Posted By: christopherrice
Subject: will this relay work?
Date Posted: September 25, 2009 at 9:52 PM

Installing an auto start alarm in a 2006 Jeep Commander. Viper 5901 and iDataLink ADS-DLSL CH3. I need a relay for the Multiplex start/accessory/keysense control. I know the ones iDataLink sells are 12VDC 1A. Will this relay work instead..

DPDT
Power Consumption - 10.8 Watts
Nominal Coil Voltage - 12VDC
Nominal Coil Current - 75mA
Coil Resistance - 160 ohms +/- 10%
Pull-in Voltage - 9.6VDC
Drop-out Voltage - 1.2VDC min.
Contact Rating - 10A at 110AC or 24VDC
Maximum Operating Voltage - 250VAC/125VDC
Minimum Load - 100mA, 5VDC

Also it requires a diode on the GWR, is a N4001 alright or is there a different diode to be using?




Replies:

Posted By: i am an idiot
Date Posted: September 25, 2009 at 10:23 PM

That relay will work fine and a 1n4001 wil be fine also.




Posted By: christopherrice
Date Posted: September 25, 2009 at 11:01 PM
Thank you, just the answer I was hoping for.


Print Page | Close Window