91 mazda 626, door lock actuator
Printed From: the12volt.com
Forum Name: Relays
Forum Discription: Relay Diagrams, SPDT Relays, SPST Relays, DPDT Relays, Latching Relays, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=13767
Printed Date: November 04, 2025 at 10:10 AM
Topic: 91 mazda 626, door lock actuator
Posted By: jpawloski
Subject: 91 mazda 626, door lock actuator
Date Posted: May 20, 2003 at 2:25 PM
HI, I have a problem with the door lock actuator i just bought, i have it all hooked up correctly with the 2 relays, wired from the acutator digram on this site. The actuator will only go into the unlock position and will not do anything else, it just freezes in the unlock postion......i am using a Impact Auto security alarm system... can anyone help...im still new at this.....
Replies:
Posted By: yodo
Date Posted: May 23, 2003 at 7:30 PM
Hey Bro, I just put an alarm into my mx6. i added all new actuators to each door with the relay. It's not your relay! It's the way you hooked it up to your alarm. I dont know much about with your brand of alarm but mine had 4 ways to wire the central locking to the alarm unit. Sounds like you have it to the negative trigger. This to happened to me. Look closely at the wiring diagrams and the chances are one wire is wrong. It's hard to say without the diagram but its easy.
Posted By: Velocity Motors
Date Posted: May 23, 2003 at 10:49 PM
Try this setup on the relays: Adding Door Lock Actuators Diagram------------- Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: jpawloski
Date Posted: May 23, 2003 at 11:57 PM
hi, thanks for the replys, ive done all the wiring according to the diagrams..but my alarm has two negative "1green, 1 violet"..door lock wires.................and then it has a extra deal called a door lock plug that comes with the alarm, and has green, blue, and red for 12v. The only way i get a response is if i attact the blue wire from the door plug, but then it just extends the actuator and won't move at all, it just stays stuck............its getting to be quite annoying.............oh well.....if anyone could help that would be awesome... Thanks In Advance
Posted By: Velocity Motors
Date Posted: May 24, 2003 at 11:33 AM
Which wires did you use for the actuator ? From what you have listed above, you should have used the GREEN & the BLUE wires for lock/unlock and the RED wire would be your polarity selector. ------------- Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: jpawloski
Date Posted: May 24, 2003 at 12:16 PM
I used the green and blue from the door plug wire. I am still new to this, bare with me. What do you connect the red wire too? THe manual on this alarm is like 1 page its very sad..lol............. thanks
Posted By: Velocity Motors
Date Posted: May 24, 2003 at 4:22 PM
Try this: - Test the output of the BLUE & GREEN wire when you leave the RED wire not connected to anything.
- Test the output of the BLUE & GREEN wire when you connect it to 12 volts +
Post your results. ------------- Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
|