Remote control Receiver to 2 x relays
Printed From: the12volt.com
Forum Name: Relays
Forum Discription: Relay Diagrams, SPDT Relays, SPST Relays, DPDT Relays, Latching Relays, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138862
Printed Date: April 25, 2024 at 7:46 PM
Topic: Remote control Receiver to 2 x relays
Posted By: digitalis49
Subject: Remote control Receiver to 2 x relays
Date Posted: April 24, 2015 at 6:46 PM
This is my 1st post to this very informative forum so I ask for your indulgence as I am a total novice to 12 volt wiring.
I have built a trailer dolly powered by a 12 volt DC 600 watt motor through 2 x 5-pin Tyco V23134-A1052-C643 relays (30, 85, 86, 87, and 87a) to control forward and reverse of the motor through 2 momentary switches.
(the electrics were done by a friend who is now unavailable)
I would like to connect a remote control receiver to this setup.
The receiver has 5 wires - 1 x positive, 1 x negative, 1 x fwd, 1 x rev, 1 x antenna.
QUESTION:
How do I connect the remote receiver to this setup?
Hope you can help.
Replies:
Posted By: howie ll
Date Posted: April 25, 2015 at 6:12 AM
Go to this page:- https://www.the12volt.com/doorlocks/page3.asp#4w
and look at the diagram actuators reverse polarity.
Lock and unlock = your forward and reverse
actuators = your motor.
This assumes that the forward and reverse wires on your receiver are (-) NEG.
TEST.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: howie ll
Date Posted: April 25, 2015 at 6:38 AM
If so wire from the output of the switches to relay 85.
I've just done a better diagram for you, note the quenching diodes, 1N4004, they protect your receiver.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: howie ll
Date Posted: April 25, 2015 at 8:02 AM
Diagram:-
remote_control.png------------- Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: digitalis49
Date Posted: April 26, 2015 at 3:26 AM
Thank you, ever so much, Howie II.
I will follow your instructions and, once completed, will send and update.
Again, thank you - from Melbourne, Australia.
Posted By: hotwaterwizard
Date Posted: April 28, 2015 at 8:08 PM
Looks like it will do the job to me.  ------------- John DeRosa (Hotwaterwizard)
Stockton California
When in doubt, try it out !
|
