Print Page | Close Window

remote start

Printed From: the12volt.com
Forum Name: Relays
Forum Discription: Relay Diagrams, SPDT Relays, SPST Relays, DPDT Relays, Latching Relays, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=26944
Printed Date: May 15, 2024 at 2:18 AM


Topic: remote start

Posted By: 90geostorm
Subject: remote start
Date Posted: February 22, 2004 at 2:08 AM

ok, i have installed previously a push button ignition, with a kill switch. then tonite i went out and got a remote switch box to run my fan, and the kill switch, the switch box can take a 150 amp load, so how would i switch my push button start over to remote on/off switching, thats if my starter system puts out lessx than 150 amp. wouldn't a relay have to be used in this regard then? and if so which relay would i use...i have a bunch of relays from my previous car which i could use, i have 4 pole relays and 6 pole relays (the 6 pole dont have wiring diagrams on the side of them) if so how would i wire up my push button to remote on/off switching???



Replies:

Posted By: 90geostorm
Date Posted: February 22, 2004 at 2:16 AM

i forgot to mention ithe relays i am using are from a geo storm  the 4 pole  is part # 8943438450 mr5b237a1

and the 6 pole part # is 8-94147-095-0

wr5a602b1

 both made by Jideco




Posted By: 90geostorm
Date Posted: February 23, 2004 at 7:20 AM
yay!!!!!!!!!!!!1 success got my remote start to work




Print Page | Close Window